Conductor string Conductor string is a string which is installed to cover unconsolidated formations, to…
Category:
Technical
-
-
Basic aspects of rock mechanics Borehole pressure required to reach tensile failure depends on: tensile…
-
Casing design considerations The objective of the casing design is to define a set of…
-
Detailed Design and Analysis In the detailed design phase, the casing designer determines the material…
-
Casing DesignPreliminary DesignTechnical
Procedures for leak-off and limit tests (LOT, LT, FIT)
by adminby adminProcedures for leak-off and limit tests (LOT, LT, FIT) Procedures for leak-off and limit tests.…
-
Casing scheme selection The output of this process is a preliminary well configuration specifying the…
-
Casing design factors This article describes the uniaxial collapse, burst, axial and compression design factors,…
-
Casing Design parameters Early collection of all the relevant data is essential and it should…
-
Casing Design Loads Introduction to Casing Design Loads (Collapse, Burst and tension Load) 1 Collapse…
-
Burst loads 1. Burst during drilling Burst loads can occur during the drilling phase due…