Influence of corrosion on casing strength Corrosion can pose a major threat to the installations…
Category:
Casing Design
-
-
Casing DesignPreliminary DesignTechnical
Procedures for leak-off and limit tests (LOT, LT, FIT)
by adminby adminProcedures for leak-off and limit tests (LOT, LT, FIT) Procedures for leak-off and limit tests.…
-
Casing scheme selection The output of this process is a preliminary well configuration specifying the…
-
Casing design factors This article describes the uniaxial collapse, burst, axial and compression design factors,…
-
Casing Design parameters Early collection of all the relevant data is essential and it should…
-
Casing Design Loads Introduction to Casing Design Loads (Collapse, Burst and tension Load) 1 Collapse…
-
Burst loads 1. Burst during drilling Burst loads can occur during the drilling phase due…
-
Pressure (Collapse and Burst) loads on casing This article describes the methods to quantify the…
-
Collapse loads 1 Evacuation during drilling Collapse loads occurring during drilling are usually the result…
-
Installation loads This articel describes the various installation loads and how they are calculated. self-weight…